When configuring a static route on a broadcast interface , you must specify the next -hop IP address.

• A.TRUE
• B.FALSE

Comment: *

Name: *

Email: *

Verification: *

A server is linked to port interface G0/0/1 of a switch. The administrator wishes to allow only this server to be linked to this interface on the switch. Which method can be used to achieve this?

• A.Configure a static MAC address binding entry of the server's MAC address and the interface in the switch.
• B.Configure a static ARP entry using the server's IP address and MAC address in the switch.
• C.It is not possible to enable a single device to be associated with an interface.
• D.Configure the default gateway of the switch to be the same as the server's IP address.

Comment: *

Name: *

Email: *

Verification: *

The Traced diagnostic tool records the 0 of each ICMP TTL timeout message so that the user can be provided with the IP address of the packet when it arrives at the destination_

• A.Destination port
• B.Source 1F1 address
• C.Source port
• D.Destination IP address

Comment: *

Name: *

Email: *

Verification: *

in the PPP, when the communication of both ends of the physical line activation is detected, it will not be available from link to link establishment phase transition stage, at this stage is mainly through the () link protocol configuration parameters

• A.NCP
• B.LCP
• C.IP
• D.DHCP

Comment: *

Name: *

Email: *

Verification: *

The following shows the Eth-Trunk information on a switch. Which of the following commands can be used to delete Eth-Trunk 1?

• A.undo interface Eth-Trunk 1
• B.inte GigabitEthernet 0/0/1
  undo eth-trunk
  quit
  inte GigabitEthernet 0/0/2
  undo eth-trunk
  quit
  undo interface Eth-Trunk 1
• C.inte GigabitEthernet 0/0/2
  undo eth-trunk
  quit
  undo interface Eth-Trunk 1
• D.inte GigabitEthernet 0/0/1
  undo eth-trunk
  quit
  undo interface Eth-Trunk 1

Comment: *

Name: *

Email: *

Verification: *