After Link-group is configured on the device, enter the display link-group 1 command, display the following information:
<USG> display link-group 1
link group 1, total 2, fault 0
GigabitEthernet0/0/1: invalid
GigabitEthernet0/0/2: fault
What conclusion can be drawn from this? (Multiple choices)

• A.The GigabitEthernet0/0/2 interface has failed
• B.GigabitEthernet0/0/2 is forced to the fault state because other interfaces in the group are faulty
• C.The GigabitEthernet0/0/1 interface has failed
• D.GigabitEthernet0/0/1 is forced to the fault state because other interfaces in the group are faulty.

Comment: *

Name: *

Email: *

Verification: *

In a Link-group with three physical interfaces, when either one of the interfaces fail, which of the following descriptions of what happens is correct? (Choose two answers)

• A.With any interface failure within the group, the system will set the other interface state to Down.
• B.When any interface group fails, the other interface status within the group does not change.
• C.When the group returns to normal after all the interfaces are up, the interface status within the entire group was re-set to Up.
• D.When the group returned to normal with one of the interfaces up, the interface status within the entire group will be re-set to Up.

Comment: *

Name: *

Email: *

Verification: *

Through the configuration of the Bypass interface, you can avoid network communication interruption caused by equipment failure and improve reliability. The power Bypass function can use any network interfaces to configure the Bypass GE parameters to achieve the Bypass function.

• A.TRUE
• B.FALSE

Comment: *

Name: *

Email: *

Verification: *

Virtual firewall technology can be implemented using IP address overlap.

• A.FALSE
• B.TRUE

Comment: *

Name: *

Email: *

Verification: *

By default, GigabitEthernet0/0/0 can be used as an out-of-band management interface in the USG2200 series.

• A.TRUE
• B.FALSE

Comment: *

Name: *

Email: *

Verification: *