OSPFv3 uses the same route advertisement method as OSPFv2: it is advertised through the network command in the OSPFv3 area view.

• A.TRUE
• B.FALSE

Comment: *

Name: *

Email: *

Verification: *

The route-policy defined by a router is as shown in the figure.

Which of the following descriptions of this configuration is correct?

• A.The cost of all routes will be set to 200
• B.Route 11.1.0.0/16 can pass node 10, and its cost is set to 300
• C.Any routes that do not pass through node 10 will be rejected.
• D.Route 11.1.0.0/16 will continue to match node 20 after passing node 10, and the final cost is set to

Comment: *

Name: *

Email: *

Verification: *

BGP routes have multiple path attributes.
When a router advertises a BGP route to its peers, the route carries multiple path attributes.
These attributes describe the characteristics of the BGP route and affect route selection in some scenarios.
The attribute is Huawei-specific.
It is valid only on the local device and is not transmitted to BGP peers.
(Enter the attribute name in lowercase as it appears in the command output about the BGP routing table.)

Comment: *

Name: *

Email: *

Verification: *

When routers running the OSPF protocol exchange DD messages, which of the following parameters will be used to elect the master-slave relationship?

• A.Area ID
• B.Router ID
• C.IP address of the interface
• D.DR priority of the interface

Comment: *

Name: *

Email: *

Verification: *

OSPF networks are classified into broadcast, P2P, P2MP, and NBMA networks. Which of the following types of networks use the default Hello time (30s)?

• A.P2P
• B.Broadcast
• C.P2MP
• D.NBMA

Comment: *

Name: *

Email: *

Verification: *