Free IBM C4040-121 Exam Dumps Questions & Answers

A tape adapter needs to be moved from one partition to another. On the HMC, after selecting the partition which currently owns the adapter, the path below is followed:
Dynamic Logical Partitioning --> Physical Adapters --> Move or Remove
After selecting the appropriate resource and target partition, "OK" is selected. The HMC returns the following error "Dynamic remove of I/O resources failed: The I/O slot dynamic logical partitioning operation failed."
What is the most likely cause of this failure?

• A.The tape device attached to the adapter has media mounted.
• B.The tape device attached to the adapter is varied-on.
• C.The adapter slot must be powered-oft through SST prior to the dynamic move operation.
• D.The tape device attached to the adapter is not connected to a power source.

When using SAN flash copy to clone a disk image for an IBM i client LPAR, message 'CP1096E Disk unit connection is missing' appears in the history log of the newly created client LPAR.
A check in SST shows the expected disk paths as 'active' and extra disk paths with a status of 'missing', a result of the reconfiguration of the disk subsystem.
What is necessary to avoid the warnings and to clean up the disk paths?

• A.Remove the missing path(s) through Hardware Service Manager.
• B.Use the Disk Path Manager tool in System Director Navigator.
• C.Re-IPL the system.
• D.Run the multipath resetter Advanced Analysis macro in SST.

A client plans to add a Power 770 server to a POWEP6 environment. What resource can the administrator use to determine if the HMC is at the correct level to support the new server firmware?

• A.ASMI
• B.System Planning Tool
• C.HMC Service Agent
• D.Power Code Matrix

A customer has a single-partition Power 720 running IBM i. They would like to install some additional adapters and implement 5 additional partitions. In addition to installing the adapters and configuring an HMC, what else is necessary?

• A.Modify the existing partition profile to not "use all resources in system" and own only what it
  needs. Reactivate the profile.
  Create partitions and profiles for the additional partitions.
• B.Create a new partition and profile for the original LPAR with only the resources the partition
  needs. Create partitions and profiles forth additional partitions.
  Delete the original partition.
  Suspend the existing partition.
• C.Configure the new partitions.
  Activate the new profiles to remove "required" features of the existing partition.
• D.Modify the profile of the existing partition and concurrently enable it.
  Resume the existing partition.
  Create partitions and profiles for the additional LPARs.

What type of Ethernet adapter is supported in an IBM i partition when using Live Partition Mobility?

• A.EtherChannel Adapter
• B.Shared Ethernet Adapter (SEA)
• C.Host Ethernet Adapter (HEA)
• D.Virtual Ethernet Adapter