Free IBM S1000-007 Exam Dumps Questions & Answers

While a system administrator is checking the TCP/IP connectivity between two systems with the traceroute command, the administrator found Fragmentation required messages in the traceroute output.
What is the likely reason for these messages?

• A.Same MTU sizes between the source and target systems. The source and target systems are using Jumbo Frames. The LPARs are using the same Virtual Switch (vSwitch) Network.
• B.The TCP buffers in the router gateway are exhausted. The source and target system are having TCP/IP communication problems.
• C.The TCP buffers between the source and the target systems are exhausted. The source and target systems are using virtual ethernet adapters.
• D.Different MTU sizes between the source and target systems. The source system is using Jumbo Frames and the target is using the default MTU size.

An administrator is configuring two Ethernet adapters in a system, and needs to route AIX packets across the two networks. Which command allows the administrator to check whether AIX is enabled for TCP/IP packet routing?

• A.ifconfig -route
• B.ioo -netroute
• C.no -a
• D.Isattr -rt

An AIX administrator successfully runs a command in SMIT. A few days later the administrator needs to know which command was run. How can the administrator determine this?

• A.look at shell history
• B.in SMIT select [F8]
• C.look at smit.script
• D.look at smit.config

A system administrator needs information about the space reclamation requests generated by LVM. Which command is required to obtain this information?

• A.iostat
• B.Ivmstat
• C.Isvg
• D.reclstat

A system administrator has changed the inter-disk policy for all logical volumes within a volume group from minimum to maximum in order to avoid disk hot spots. What is required for this new policy to take effect and preserve the data?

• A.Use the varyof fvg and varyonvg commands on the volume group.
• B.Use the migratevg command on the volume group.
• C.Recreate all the logical volumes within the volume group.
• D.Reorganize the volume group with the reorgvg command.