Which of these is incorrect?

• A.A route filter is a list of prefixes.
• B.A prefix list is a list of prefixes.
• C.A prefix list can be used in multiple terms in a single policy or in different policies.
• D.A route filter can be used in multiple terms in a single policy or in different policies.

Comment: *

Name: *

Email: *

Verification: *

The output of the show interfaces terse command is shown below.
What does this indicate?
1. Interface Admin Link Proto Local Remote
2. xe-0/0/0 up down

• A.The interface is up but has been administratively turned off.
• B.Layer 1 on the interface is up but Layer 2 is down.
• C.Layer 2 on the interface is up but Layer 3 has not been configured.
• D.The interface is administratively up but the link status is down.

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

Which statement is correct when traffic is received from 10.10.10.4?

• A.The traffic is counted and accepted
• B.The traffic is only accepted
• C.The traffic is only rejected
• D.The traffic is counted and rejected

Comment: *

Name: *

Email: *

Verification: *

What are three valid software release designations for the junos OS? (Choose three.)

• A.B
• B.T
• C.Z
• D.R
• E.X

Comment: *

Name: *

Email: *

Verification: *

Referring to the exhibit, you want to block HTTP access to Web-Server from the subnet where Mal-User is located. All other traffic should be permitted.

Which firewall filter configuration do you use?

• A.[edit firewall family inet filter STOP-MAL-USER] user@router# show term one { from { source-address { 200.200.200.0/24; } destination-address { 100.100.100.10/32; } protocoltcp; destination-port http; } then reject; } term two { then { accept; } }
• B.[edit firewall family inet filter STOP-MAL-USER] user@router# show term one { from { source-address { 100.100.100.0/24; } destination-address { 200.200.200.1/32; } protocoltcp; destination-port http; } then accept; } term two { then { reject; } }
• C.[edit firewall family inet filter STOP-MAL-USER] user@router# show term one { from { source-address { 100.100.100.0/24; } destination-address { 200.200.200.1/32; } protocoltcp; destination-port http; } then reject; } term two { then { accept; } }
• D.[edit firewall family inet filter STOP-MAL-USER] user@router# show term one { from { source-address { 200.200.200.0/24; } destination-address { 100.100.100.10/32; } protocoltcp; destination-port http; } then accept; } term two { then { reject; } }

Comment: *

Name: *

Email: *

Verification: *