Free Juniper JN0-333 Exam Dumps Questions & Answers

Click the Exhibit button.

You have an IPsec tunnel between two devices. You clear the IKE security associations, but traffic continues to flow across the tunnel.
Referring to the exhibit, which statement is correct in this scenario?

• A.The traffic is no longer encrypted
• B.The IPsec security association is independent from the IKE security association
• C.The IKE security association immediately reestablishes
• D.The traffic is using an alternate path

Which process describes the implementation of screen options on an SRX Series device?

• A.Configured screen options are applied only to the first packet that is processed in a stateful session.
• B.Configured screen options are applied to all packets that are processed by the stateful session firewall processor.
• C.Configured screen options are only applied when traffic does not match a valid route.
• D.Configured screen options are only applied when traffic does not match a valid policy.

Click the exhibit button.

Referring to the exhibit, which statement is true?

• A.Packets entering the interface are being dropped because of a stateless filter.
• B.Packets entering the interface are getting dropped because the interface is not bound to a zone.
• C.Packets entering the interface matching an ALG are getting dropped.
• D.TCP packets entering the interface are failing the TCP sequence check.

Clients at a remote office are accessing a website that is against your company Internet policy. You change the action of the security policy that controls HTTP access from permit to deny on the remote office SRX Series device. After committing the policy change, you notice that new users cannot access the website but users that have existing sessions on the device still have access. You want to block all user sessions immediately.
Which change would you make on the SRX Series device to accomplish this task?

• A.Add the set security policies policy-rematch parameter to the configuration and commit the change.
• B.Issue the commit full command from the top of the configuration hierarchy.
• C.Add the security flow tcp-session strict-syn-check option to the configuration and commit the change.
• D.Add the set security flow tcp-session rst-invalidate-session option to the configuration and commit the change.

Click the Exhibit button.

You are monitoring traffic, on your SRX300 that was configured using the factory default security parameters.
You notice that the SRX300 is not blocking traffic between Host A and Host B as expected.
Referring to the exhibit, what is causing this issue?

• A.You have not created address book entries for Host A and Host B.
• B.The default policy has not been committed.
• C.The default policy permits intrazone traffic within the Trust zone.
• D.Host B was not assigned to the Untrust zone.