Which statement is correct about trunk ports?

• A.By default, a trunk port can have only a single VLAN assigned.
• B.Trunk ports must have an IRB assigned to accept VLAN tagged traffic.
• C.By default, trunk ports accept only VLAN tagged traffic.
• D.trunk ports must have an IRB assigned to accept untagged traffic.

Comment: *

Name: *

Email: *

Verification: *

Exhibit.

You manage the layer 2 network shown in the exhibit, You experience a failure on the ge-0/0/0 link between Swicth-1 and Switch-2.
Which statement is correct about expected behavior?

• A.Swicth-2's ge0/0/2 port role and state will transition to root and forwarding.
• B.Switch-2's ge0/0/2 port role and state will remain as designated and forwarding.
• C.Switch-2 will become the root bridge for a separate RSTP topology.
• D.Switch-2 will remove itself from the RSTP topology.

Comment: *

Name: *

Email: *

Verification: *

Which two situations would cause dynamic ARP inspection to drop traffic? (Choose two.)

• A.If no IP-to-MAC address entry exists in the DHCP snooping database
• B.If the IP address in the ARP packet is deemed invalid
• C.If the requested MAC address exceeds the configured limit on the port
• D.If the ARP packet comes from a port that has been configured as trusted

Comment: *

Name: *

Email: *

Verification: *

Exhibit.

In the exhibit, each IP subnet in the network is associated with a unique VLAN ID.
Which action will ensure that Host C will communicate with Host A and Host B?

• A.Configure an IRB interface for each VLAN and associate It with its corresponding VLAN.
• B.Configure all switch ports connecting to the host devices as access ports associated with a common VLAN.
• C.Configure all switch ports connecting to the host devices as trunk ports associated with all VLANs
• D.Configure a port-based ACL that permits inter-VLAN routing for all configured VLANs.

Comment: *

Name: *

Email: *

Verification: *

Click the Exhibit button.

Referring to the exhibit, all users connected to the same VLAN can communicate with each other, but not with users on other VLANs in this network.
What must be configured to enable communication between the VLANs?

• A.A logical IRB interface must be created and assigned to each VLAN.
• B.A separate routing device is required to forward traffic between the configured VLANs.
• C.A single logical IRB interface must be created and assigned to all three VLANs.
• D.The switch ports to which the users are connected should be configured as trunk ports.

Comment: *

Name: *

Email: *

Verification: *