Click the Exhibit button.

Your switches are managed using Junos Space Network Director. You want to secure the switches using a Network Director filter profile. A filter profile containing one term shown in the exhibit is deployed to ports on managed devices.
Which traffic will be accepted by the filter?

• A.All traffic will be accepted.
• B.Traffic containing a source MAC of 02:85:05:00:00:00/24 will be accepted.
• C.No traffic will be accepted.
• D.Traffic containing a destination MAC of 02:85:05:00:00:00/24 will be accepted.

Comment: *

Name: *

Email: *

Verification: *

You added a new ESXi host connected to port ge-0/0/1. One of the VMs configured with VLAN 10 is not reachable from any other device on the switch. To troubleshoot, you decide to verify if the VM's MAC address is learned properly under VLAN 10.
Which command would you use in this scenario?

• A.show ethernet-switching table vlan-id 10
• B.show interfaces ge-0/0/1 detail
• C.show vlans 10
• D.monitor interface ge-0/0/1

Comment: *

Name: *

Email: *

Verification: *

Your network is configured with dynamic ARP inspection (DAI) using the default parameters for
all the DHCP and ARP related configurations.
You just added a new device connected to a trunk port and configured it to obtain an IP address
using DHCP.
Which two statements are correct in this scenario? (Choose two.)

• A.The DHCP server assign the IP addressing information to the new device.
• B.DAI validates the ARP packets for the new device against the DHCP snooping database.
• C.The SRP request and response packets for the new device will bypass DAI.
• D.DHCP snooping adds the DHCP assigned IP address for the device to its database.

Comment: *

Name: *

Email: *

Verification: *

Your network connect to the Internet Through two different ISPs using EBGP. You must ensure that ISP1 is the primary path used for all traffic entering your network while using ISP2 as a backup path.
In this scenario, which statement is correct?

• A.You should your local AS number three times on routes that you are sending to ISP2.
• B.You should assign a higher local preference on routers that you are sending to ISP1.
• C.You should use a lower MED value on routes sent to ISP1.
• D.You should change the next hop for all routes sent to ISP2.

Comment: *

Name: *

Email: *

Verification: *

What are two characteristics of OSPF ABRs? (Choose two.)

• A.ABRs transmit routing information between the backbone and other areas.
• B.ABRs cannot be part of the backbone and another area at the same time.
• C.ABRs inject information from outside the OSPF domain.
• D.ABRs link two OSPF areas

Comment: *

Name: *

Email: *

Verification: *