Free Juniper JN0-360 Exam Dumps Questions & Answers

-- Exhibit --
user@r1> show interfaces terse ge-1/0/0
Interface Admin Link Proto Local Remote
ge-1/0/0 up up
ge-1/0/0.0 up up inet6 fe80::226:88ff:fe02:7481/64
fec0:0:0:2003::1/64
-- Exhibit --
Click the Exhibit button.
You run the command show interfaces terse ge-1/0/0 and see the output shown in the exhibit.
Why are two addresses being shown for this interface?

• A.The two addresses being seen are the link-local and site-local.
• B.Two addresses are seen because the loopback address of the router is associated with the interface.
• C.Two addresses are assigned in IPv6, one for the physical and one for the logical interface.
• D.An IPv6 address conflict is being seen; verify your interface configuration for problems.

Which three statements are correct about VRRP? (Choose three.)

• A.It requires speakers to be configured with BFD.
• B.It is confined to the local network with a TTL of 255.
• C.It uses the virtual router's lo0 address for LAN communications.
• D.It uses multicast address 224.0.0.18.
• E.It uses a virtual router MAC address for LAN communications.

An RSVP LSP in your network is operational but you are receiving complaints about network throughput across the LSP. You suspect that the RSVP bandwidth was omitted from the router configuration.
Which operational mode command will help you verify your suspicions?

• A.show interfaces terse
• B.show mpls lsp extensive
• C.show rsvp bandwidth
• D.show rsvp neighbor detail

Click the Exhibit button.

In the exhibit, R1 is sending the 172.16.100.0/24 route to R2 through EBGP. R2 has IBGP sessions to R3 and R4, but they are not installing the route. All BGP sessions are established.
Which two actions would enable R3 and R4 to install the route from R2? (Choose 2.)

• A.Configure an IGP export policy with a next-hop self action on R2.
• B.Advertise the R1-R2 link into the IGP.
• C.Configure a BGP export policy with a next-hop self action on R2.
• D.Configure the cluster-id parameter under the R2 IBGP group.

You have recently configured MSTP on two switches in your network to participate in the same MSTP region. You issue the show spanning-tree mstp configuration command on both switches and notice that the configuration digests do not match. What does this mismatch indicate?

• A.You should ensure that the max-age and hello timers are equal on both switches.
• B.Everything is functioning as expected because the configuration digests should not match.
• C.You should ensure that the bridge IDs and priority values are unique on both switches.
• D.You should ensure that the MSTIs and their VLAN IDs are equal on both switches.