Click the Exhibit.

The router with the configuration shown in the exhibit has two interfaces, both of which are operational and can pass traffic. These interfaces are connected to two different routers, both of which are configured for OSPF area 0.0.0.1. The router has received LSAs and can now send traffic into the backbone area.
Which two statements are correct? (Choose two.)

• A.The router has two OSPF adjacencies.
• B.The router is an ASBR.
• C.The router is an ABR.
• D.The router has only a single OSPF adjacency.

Comment: *

Name: *

Email: *

Verification: *

You are asked to change the default TTL handling behavior on your Junos device to ensure that the RSVP-signaled LSPs in your MPLS network cannot be mapped.
Which configuration should be performed to accomplish this task?

• A.Configure the no-decrement-ttl parameter for each LSP on the egress device
• B.Configure the no-decrement-ttl parameter for each LSP on the ingress device
• C.Configure the no-propagate-ttl parameter for each LSP on the egress device
• D.Configure the no-propagate-ttl parameter for each LSP on the ingress device

Comment: *

Name: *

Email: *

Verification: *

You want to save adjacency formation time between two routers participating in OSPF, as well as reduce the size of the OSPF link-state database.
How would you accomplish these tasks?

• A.Define a point-to-point connection.
• B.Specify a designated router.
• C.Specify a backup designated router.
• D.Configure a virtual link.

Comment: *

Name: *

Email: *

Verification: *

Which two statements ate correct about the actions taken as the packet traverses the service provider MPLS network from Site 1 to Site 2 as shown in the exhibit?
(Choose two.)

• A.R2 will perform a lookup using the mpls.0 table.
• B.R1 will perform a lookup using the mpls.0 table.
• C.R2 will perform a lookup using the inet.3 table.
• D.R1 will perform a lookup using the lnet.3 table.

Comment: *

Name: *

Email: *

Verification: *

Referring to the exhibit, which two statements are correct? (Choose two.)

• A.The R2 device is an ABR.
• B.The OSPF Interfaces are configured as point-to-point.
• C.The ge-0/0'1.0 Interface is configured as passive.
• D.Junos OS default OSPF hello timers and dead intervals are used on all interfaces.

Comment: *

Name: *

Email: *

Verification: *