Free Juniper JN0-637 Exam Dumps Questions & Answers

You Implement persistent NAT to allow any device on the external side of the firewall to initiate traffic.

Referring to the exhibit, which statement is correct?

• A.The target-host parameter should be used instead of the any-remote-host parameter.
• B.The any-remote-host parameter does not support interface-based NAT and needs an IP pod to work.
• C.The port-overloading parameter needs to be turned off in the NAT source interface configuration
• D.The target-host-port parameter should be used instead of the any-remote-host parameter

In a multinode HA environment, which service must be configured to synchronize between nodes?

• A.IPsec VPN
• B.PKI certificates
• C.IDP
• D.Advanced policy-based routing

Which encapsulation type must be configured on the lt-0/0/0 logical units for an interconnect logical systems VPLS switch?

• A.encapsulation ethernet
• B.encapsulation ethernet-bridge
• C.encapsulation ethernet-vpls
• D.encapsulation vlan-vpls

You are asked to establish a hub-and-spoke IPsec VPN using an SRX Series device as the hub.
All of the spoke devices are third-party devices.
Which statement is correct in this scenario?

• A.You must always peer using loopback addresses when using non-Junos devices as your spokes.
• B.You must statically configure the next-hop tunnel binding table entries for each of the third-party spoke devices.
• C.You must ensure that you are using aggressive mode when incorporating third-party devices as your spokes.
• D.You must create a policy-based VPN on the hub device when peering with third-party devices.

Exhibit:


Referring to the exhibit, which statement is true?

• A.SRG1 is configured in hybrid mode.
• B.If SRG1 moves to peer 2, peer 1 will drop packets sent to the SRG1 interfaces.
• C.If SRG1 moves to peer 2, peer 1 will forward packets sent to the SRG1 interfaces.
• D.The ICL is encrypted.