Free Juniper JN0-647 Exam Dumps Questions & Answers

Click the Exhibit.


You have just configured on an OSPF adjacency between two routers. After you commit the configuration, you notice that your adjacency is not up.
Referring to the exhibit, what would cause the problem?

• A.You must configure bfd on R2.
• B.You must configure lo0 on R2.
• C.You must configure on interface-type on R2.
• D.You must configure hello and dead intervals on R1.

You want to deploy MSTP with multiple regions. Each region should have a unique root bridge to accommodate a set of VLANs. Which three configuration elements must watch on switches participating in this deployment scenario? (Choose three.)

• A.CST BPDU parameters
• B.bridge priority
• C.revision level
• D.MSTI toVLAN mapping
• E.configuration name

Your network provider supports multicast traffic but your provider network does not. You want to allow multicast hosts outside of your network to receive multicast traffic sourced within your network.
How would you satisfy this requirement?

• A.Use MSDP peering with your provider.
• B.Use an automatic multicast tunnel gateway at the edge of your network.
• C.Use AutoVPN to connect to the remote hosts.
• D.Use an MP-BGP session to your provider to pass multicast traffic.

Click the Exhibit.

Referring to the exhibit, you are receiving multiple routes from ISP3 through two EBGP neighbors. You must ensure that all traffic leaving R1 destined to the networks advertised by ISP3 go through ISP2.
What should you do on R1 to accomplish this task?

• A.Create and apply an import policy to set the local preference on routes learned from ISP2 to be higher than those learned from ISP1.
• B.Create and apply an import policy to set the local preference on routes learned from ISP2 to be lower than those learned from ISP1.
• C.Create and apply an import policy to set the route preference on routes learned from ISP2 to be lower than those learned from ISP1.
• D.Create and apply an import policy to set the route preference on routes learned from ISP2 to be higher than those learned from ISP1.

Click the Exhibit.


Referring to the exhibit, how is R1 learning the route from R2?

• A.R2 has an export policy with external type 2 configured.
• B.R2 has an export policy with external type 1 configured.
• C.R2 has interface ge-0/0/2 configured as a passive interface under OSPFv3.
• D.R2 has interface ge-0/0/2 configured in another area under OSPFv3.