Click the Exhibit button.

You are implementing CoS for a custom application that is labeling its packets with DSCP code-point 101111.
You have applied the configuration shown in the exhibit, but note that while some custom application traffic ingressing on ge-0/0/1 transits the SRX Series device successfully, packets ingressing all other ge-* interfaces are being dropped.
Which action should you take to solve this problem?

• A.Apply the rate-limit-efpolicer to all ge- interfaces.
• B.Remove the BA classifier from all ge- interfaces.
• C.Configure a scheduler and scheduler map for expedited-forwarding and apply to all interfaces.
• D.Modify the BA classifier to assign code point 101111 to loss priority low.

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

Referring to the exhibit, a RMSM network is set up to enable communication between multicast devices.
Which statement is true in this scenario?

• A.After the formation of the shortest-path free, a prune message is sent from R1 to R5.
• B.After the formation of the shortest-path tree, a join message is sent from R1 to R5
• C.After the formation of the shortest-path tree, a join message is sent from R2 to R1.
• D.After the formation of the shortest-path tree, a prune message is sent from R1 to R2.

Comment: *

Name: *

Email: *

Verification: *

You have PIM SM multicast configure and running in a network environment comprised of EX4300 devices. Your customer report increased delay when switching channels using IPTV. To help decrease the delay, you implement PIM join balancing. You add the set protocol pim join-load-balance command to the configuration. After committing, you notice that the flows are still using one path.
In this scenario, which statement is correct?

• A.The interface must be specified to use for load balancing
• B.PIM join load-balancing also be configured.
• C.IGMP snooping must be configured.
• D.The clear pim join-distribution command must be issued.

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

Referring to the exhibit, which two statements are true with regards to deploying CoS? (Choose two.)

• A.You should apply BA classifiers on the LAN-facing interfaces of the routers
• B.You should apply MF classifiers on the LAN-facing interfaces of the routers
• C.You should apply MF classifiers on the point-to-point interfaces of the routers
• D.You should apply BA classifiers on the point-to point interfaces of the routers.

Comment: *

Name: *

Email: *

Verification: *

Exhibit:

You recently implemented the configurations shown in the exhibit. After committing these changes, the community devices connected to AS-1 are not able to communication with the appropriate community devices connected to AS-2.
What must be to allow these community devices to communicate?

• A.You must configure an isolation VLAN ID under the vlan-pri vlan on the AS-2 switch.
• B.You must configure the ge-0/0/10 interface on AS-1 as the inter-switch link.
• C.You must configure the ge-0/0/1 interface on both switches the inter-switch links.
• D.You must configure an isolation VLAN ID under the vlan-pri VLAN on both switches.
• E.You must configure to allow the ge-0/0/1 interface on AS-1 as the inter-switch.

Comment: *

Name: *

Email: *

Verification: *