Free NACE NACE-CIP1-001 Exam Dumps Questions & Answers

Removal of welds splatter is required:

• A.On every job
• B.When NACE/SSPC abrasive blast standards are specified
• C.When ISO abrasive blast standards are specified
• D.When specifically identified in the owner's specification

What is the minimum recommended distance away from an edge that an inspector should take a measurement with a dial-type magnetic pull-off Dry Film Thickness (DFT) gauge?

• A.2.5 cm (1 inch)
• B.1 cm (.39 inch)
• C.6.35 cm (2.5 inch)
• D.2.5 millimeters (.10 inch)

Surface profile describes:

• A.The level of surface roughness required after abrasive blasting
• B.The general condition of the surface required after abrasive blasting
• C.The level of surface cleanliness required after abrasive blasting
• D.The initial condition of the surface prior to abrasive blasting

A magnetic pull-off type gauge is a good choice when:

• A.Performing an adhesion test
• B.When working on non-ferrous metals
• C.When an intrinsically safe tool is required
• D.Accuracy is not required

When using a sling physchrometer a very large difference between the wet and dry bulb readings indicates:

• A.Low Relative Humidity
• B.Low Surface Temperature
• C.High Relative Humidity
• D.High Surface Temperature