Free Network Appliance NS0-175 Exam Dumps Questions & Answers

An administrator plans to deploy a Nexus 1000V with VMware ESXi in a FlexPod environment. The administrator wants to ensure proper operation under multiple failure scenarios.
In this scenario, which two configuration actions conform to Cisco's best practices for high availability? (Choose two.)

• A.Change the configuration of the UCS from end-host mode to switch mode.
• B.Configure a dynamic vNIC policy on the service profile for the ESXi host.
• C.Ensure that the Nexus 1000V control and data traffic are on different VLANs.
• D.Disable fabric failover on the adapters in a UCS service profile.

The FlexPod Data Center with VMware vSphere 5.1 solution utilizes a clustered file system that allows multiple hosts simultaneous read and write access to a single volume.
What is the name of this file system?

• A.VHDX
• B.VMFS
• C.FAT
• D.NTFS

The traceroute command is used to ____.

• A.show the state of each interface
• B.print the route packets take to a network host
• C.report interface activity in Kbps
• D.display a list of active sockets for each protocol

What are three requirements for all FlexPod Datacenter solutions? (Choose three.)

• A.redundant boot-from-SAN LUN paths
• B.a separate 100 Mbps Ethernet/1 Gbps Ethernet out-of-band management network
• C.two Cisco UCS 6200, 6300, or 6400 Series Fabric Interconnects in a redundant configuration
• D.a pair of Fabric Extenders in a redundant configuration
• E.two NetApp storage controllers in a high-availability (HA) pair configuration

For FI 6248 with a GEM module, what is the possible assignment of ports for native Fibre Channel and Ethernet?

• A.Eth ports: 1-21, 33-48, Fibre Channel ports. 22-32
• B.Eth ports: 1-18, 33-40, Fibre Channel ports. 19-32, 41-48
• C.Eth ports: 1-21, Fibre Channel ports. 22-48
• D.Eth ports: 1-16, 41-48, Fibre Channel ports. 17-40