Instant Access NetworkAppliance.NS0-184.v2022-04-26.q21 Actual Practice Test Engine for Free (Page 3)

40%off

NS0-184 Premium Dumps

Latest NS0-184 Exam Premium Dumps provide by TrainingQuiz.com to help you Passing NS0-184 Exam! TrainingQuiz.com offers the updated NS0-184 exam dumps, the TrainingQuiz.com NS0-184 exam questions has been updated to correct Answer. Get the latest TrainingQuiz.com NS0-184 pdf dumps with Exam Engine here:

(60 Q&As Dumps, 40%OFF Special Discount: DumpsDB)

Question 6

Click the Exhibit button.

You want to add a FAS2750 HA pair to an existing 6-node cluster.
Referring to the exhibit, which action would you perform to begin adding the node?

A.Use the node setup wizard and select 0a as the management interface.
B.Reboot the node and enter maintenance mode and run the Cluster Setup wizard.
C.Use the back command to begin the Cluster Setup wizard.
D.Use the exit or quit commands then run the cluster setup command.

Question 7

Click the Exhibit button.

A customer has two Cisco 40GbE data switches. They want to connect the switches to an AFF A400 HA pair. The switches and the AFF A400 are approximately seven meters apart.
Referring to the exhibit, which two supported actions would allow you to accomplish this task? (Choose two.)

A.Relocate the switches or the AFF A400 so that the distance is less than five meters.
B.Change the requirement for Ethernet cables.
C.Install 10 meter NetApp supported copper cables.
D.Change the requirement for optical cables.

Question 8

A customer has a current AFF ASA A700 cluster and they want to expand the cluster by adding a second AFF ASA A700 HA pair.
In this scenario, which step would be required to accomplish this task?

A.Enable ALUA between the two HA pairs to allow cluster backend traffic.
B.Install a BES-53248 cluster switch and convert the AFF ASA A700 from a switchless to switch cluster.
C.Install a Brocade FC switch and create zoning between the original cluster and the new cluster.
D.The customer will need to create a separate cluster for the second AFF ASA A700 pair.

Question 9

In an ONTAP 9.7 cluster, which LIF role is used for sending AutoSupport, establishing Network Time Protocol (NTP), and loading software updates?

A.cluster management LIF
B.cluster LIF
C.data LIF
D.node management LIF

Question 10

After a system panic, the NetApp Support team advises you to run the sldiag command.
Which two actions must be performed before you use this command? (Choose two.)

A.At the storage system prompt, type boot_maintenance.
B.At the storage system prompt, type halt.
C.At the LOADER prompt, type boot_diags.
D.At the LOADER prompt, type boot_maintenance.