You use the system health subsystem show command to troubleshoot your newly installed ONTAP cluster.
In this scenario, which two health outputs would this command show you? (Choose two.)

• A.node CPU utilization
• B.cluster switch cabling
• C.data switch cabling
• D.shelf connectivity

Comment: *

Name: *

Email: *

Verification: *

A customer is creating a new SVM to host iSCSI LUNs for a Hyper-V cluster. You need to successfully map the new LUNs and make them visible to the Hyper-V cluster.
In this scenario, which host information is required to accomplish this task?

• A.WWNNs
• B.WWPNs
• C.host names
• D.IQNs

Comment: *

Name: *

Email: *

Verification: *

You are installing a new ONTAP 9.7 cluster by following the installation and setup poster. You are ready to complete the initial cluster setup. You have connected your laptop to the management switch. However, when browsing the network, you are unable to discover the ONTAP controllers.
Which statement explains this behavior?

• A.You do not have a static IP address.
• B.You do not have network discovery enabled.
• C.You do not have a default gateway set.
• D.You do not have IPv6 configuration set.

Comment: *

Name: *

Email: *

Verification: *

After the Installation of a new NetApp FAS system, you use theNetAppDocs tool for site design documentation.
In this scenario, in which three document formats would you create an inventory report? (Choose three.)

• A..xlsx
• B..ps
• C..docx
• D..pdf
• E..html

Comment: *

Name: *

Email: *

Verification: *

After a system panic, the NetApp Support team advises you to run the sldiag command.
Which two actions must be performed before you use this command? (Choose two.)

• A.At the storage system prompt, type boot_maintenance.
• B.At the LOADER prompt, type boot_maintenance.
• C.At the LOADER prompt, type boot_diags.
• D.At the storage system prompt, type halt.

Comment: *

Name: *

Email: *

Verification: *