You have completed a base installation and system registration of an AFF A250 system, but you notice that you have one failed drive. Neither un-failing nor reseating the drive repaired it.
In this scenario, which two actions should you take? (Choose two.)

• A.Run Active IQ Config Advisor to collect all the logs on the system.
• B.Power off the system until the drive has been replaced.
• C.Ask the customer for a drive with the same capacity and replace it.
• D.Ask the customer to open a technical case with NetApp Support.

Comment: *

Name: *

Email: *

Verification: *

You want to add two new nodes to an existing 4-node cluster.
In this situation, what must be considered regarding the cluster interconnect?

• A.Customer IP addresses must be provided.
• B.Class A subnet settings must be used.
• C.When a new node joins a cluster, IP addresses are generated automatically.
• D.IP addresses are used from the data LIFs.

Comment: *

Name: *

Email: *

Verification: *

Your customer is migrating data from a legacy FAS8020 system that runs ONTAP 9.5 software to a new AFF A250 MetroCluster over IP configuration.
In this scenario, which two methods would be supported to migrate the data? (Choose two.)

• A.Perform a controller swap from the FAS8020 to the AFF A250s.
• B.Create a 4-node cluster on one side and use the vol move command to migrate the data.
• C.Use a host-based copy migration method.
• D.Configure a SnapMirror copy between the FAS8020 and the AFF A250 systems.

Comment: *

Name: *

Email: *

Verification: *

A customer is creating a new SVM to host iSCSI LUNs for a Hyper-V cluster. You need to successfully map the new LUNs and make them visible to the Hyper-V cluster. In this scenario, which host information is required to accomplish this task?

• A.IQNs
• B.WWNNs
• C.WWPNs
• D.host names

Comment: *

Name: *

Email: *

Verification: *

You have a 2-node FAS8300 ONTAP 9.8 cluster that serves SMB shares. You are configuring interface groups for higher performance and resiliency.
Which two NetApp best practices should you follow to satisfy these performance and resiliency requirements? (Choose two.)

• A.Use ports from different NICs.
• B.Use ports from the same NICs.
• C.Use ports with the same chipsets.
• D.Use ports with different chipsets.

Comment: *

Name: *

Email: *

Verification: *