Free Network Appliance NS0-193 Exam Dumps Questions & Answers

Which command should be used to start a packet trace in ONTAP 9.5?

• A.network tcpdump start
• B.network traceroute
• C.system node run -node * pktt start
• D.vserver security trace

After a successful upgrade from ONTAP 9.3 to ONTAP 9.5, you have a compatibility issue and must downgrade to ONTAP 9.3.
Which action must beperformed to accomplish this task?

• A.ONTAP must be directly downgraded to ONTAP 9.0 first.
• B.ONTAP must be directly downgraded to ONTAP 9.3 first.
• C.ONTAP must be directly downgraded to ONTAP 9.4 first.
• D.ONTAP must be directly downgraded to ONTAP 9.2first.

An administrator notices that the clustered Data ONTAP 8.2.3 controllers are less responsive than normal. You use On Command Performance Manager but do not see obvious problems, yet, this particular issue is constant. Users are starting to complain.
Which tool would you use to collect data to help diagnose this issue?

• A.Auto Support
• B.Perfmon
• C.Performance Archive
• D.Perfstat

A FAS system that is backed by 7200 RPM drives is experiencing extremely latent writes and slow but less latent reads.

Referring to the exhibit, what are two reasons for this result? (Choose two.)

• A.NVRAM is too small for the controller.
• B.The disks are latent.
• C.Indirect I/O is causing most of the latency.
• D.The controller is in back-to-back consistency points.

A customer is installing a new system and has determined that they have a broken disk.
What information is required to open a NetApp Support case?

• A.mainboard rev. id
• B.disk shelf serial number and shelf ID number
• C.disk HBA firmware and serial number
• D.serial number or system ID