Free Network Appliance NS0-507 Exam Dumps Questions & Answers
| Exam Code/Number: | NS0-507Join the discussion |
| Exam Name: | NetApp Certified Implementation Engineer - SAN, Clustered Data ONTAP |
| Certification: | Network Appliance |
| Free Question Number: | 90 |
| Publish Date: | Aug 14, 2026 |
| # of views: | 2801 |
|
|
|
Which NetApp resource would you use to validate the maximum number of FC hops that are supported by a switch vendor?
Your vSphere administrator asked you to create an additional 5GB boot LUN for their new
ESX1 installation. To complete this request, you have entered the following CLI commands:
lun create -vserver svm1 -volume boot -lun exsi_1 -size 5G -ostype vmware igroup create - vserver svm1 -igroup esxi_1 -protocol fcp -ostype vmware -initiator 50:01:43:80:05:68:5f:
B6
However, the vSphere administrator has reported that they are unable to see the newly configured LUN.
What must you do to solve the problem?
You notice that reporting nodes are not mapped on a LUN in a 4-node cluster that originally ran an older version of ONTAP. In this scenario, which command would you use to add only the local HA pair to the reporting nodes for the /vol/data/lun1/LUN?
You are asked to configure the Service Processor on a newly installed node, and must verify the following command:
system-service processor network modify-node local-address-family IPv4-enable true-ip- address 192.168.123.98-netmask 255.255.255.0
Which statement about this command is true?