What uses the Access Volume? (Choose the best answer.)

• A.SMagent
• B.Redundancy Check
• C.XOR parity calculations
• D.Asymmetric Logical Unit
• E.Legacy operating environments

Comment: *

Name: *

Email: *

Verification: *

During a routine review of firewall logs, an analyst identified that an IP address from the organization's server subnet had been connecting during nighttime hours to a foreign IP address, and had been sending between 150 and 500 megabytes of data each time. This had been going on for approximately one week, and the affected server was taken offline for forensic review.
Which of the following is MOST likely to drive up the incident's impact assessment?

• A.PII of company employees and customers was exfiltrated.
• B.The local root password for the affected server was compromised.
• C.IP addresses and other network-related configurations were exfiltrated.
• D.Raw financial information about the company was accessed.
• E.Forensic review of the server required fall-back on a less efficient service.

Comment: *

Name: *

Email: *

Verification: *

Which feature creates a full physical clone of a volume on an E-Series or EF-Series storage system?

• A.Snapshot image
• B.Volume Copy
• C.Snapshot volume
• D.FlexClone

Comment: *

Name: *

Email: *

Verification: *

Which sequence describes the procedures for hot-adding an additional expansion enclosure to an existing E-Series configuration? (Choose the best answer.)

• A.Power on expansion enclosure,add one ESM cable between it andanother available expansion port, disrupt the other SAS connection to add second cable, check SANtricity for addition of the new enclosure.
• B.Add one ESM cable between it and another available expansion port, disrupt the other SAS connection to add second cable, check SANtricity for addition of the new enclosure, power on expansion enclosure.
• C.Add one ESM cable between it and another available expansion port, disrupt the other SAS connection to add second cable, power on expansion enclosure, check SANtricity for addition of the new enclosure.
• D.Power on expansion enclosure, add one ESM cable between it and another available expansion port, check SANtricity for addition of the new enclosure, disrupt the other SAS connection to add second cable

Comment: *

Name: *

Email: *

Verification: *

Which feature used on E-Series controllers enables them to ship I/O to the alternate controller?

• A.ALUA
• B.RDAC
• C.TPGS
• D.AVT

Comment: *

Name: *

Email: *

Verification: *