Instant Access NetworkAppliance.NS0-516.v2023-03-06.q63 Actual Practice Test Engine for Free (Page 6)

40%off

NS0-516 Premium Dumps

Latest NS0-516 Exam Premium Dumps provide by TrainingQuiz.com to help you Passing NS0-516 Exam! TrainingQuiz.com offers the updated NS0-516 exam dumps, the TrainingQuiz.com NS0-516 exam questions has been updated to correct Answer. Get the latest TrainingQuiz.com NS0-516 pdf dumps with Exam Engine here:

(101 Q&As Dumps, 40%OFF Special Discount: DumpsDB)

Question 21

Which command collects detailed diagnostic information from a Brocade FC switch?

A.showdiag
B.supportshow
C.showsupport
D.diagshow

Question 22

What are two methods for setting the host protocol configuration on the E2800 controller with a 4-port 16Gbps FC or 10Gbps iSCSI SFP+ host interface card (HIC)? (Choose two.)

A.Change the Feature Pack in the SANtricity System Manager
B.Set at the factory, based on the order
C.Change the QSFP type in the HIC
D.Set in the Hardware tab using SANtricity System Manager

Question 23

What system file is used during the controller start-of-day sequence to determine various SCSI parameters and other host-type specific settings for an E-Series system? (Choose the best answer.)

A.Unreadable Sectors Log
B.ESM Firmware
C.NVSRAM
D.Major Event Log

Question 24

A customer needs to add an EF280 with FC into its existing Brocade fabric but the FC ports in the SANtricity System Manager are showing the FC ports as down and the LED on the FC HIC is amber.
Which three tasks does the installer need to complete to solve this problem? (Choose three.)

A.Verify that the ports are enabled on the switch
B.Verify that the server HBA has the boot BIOS enabled
C.Verify that the cables are plugged into the switch
D.Verify that the switch zone has the WWPNs for the EF280 and Server HBAs
E.Verify that the EF280s management port is up

Question 25

Is this E5624 storage system cabled according to recommended practices? If not, why?

A.No. Each controller is only cabled to one set of ESMs in the disk shelves.
B.Yes. The cabling configuration is correct.
C.No. The controllers should be cabled to the last disk shelf first.
D.No. Controller A should be cabled to the right ESMs, instead of the left ESMs and Controller B should be cabled to the left ESMs instead of the right ESMs.