During normal operation, a failure was detected on an E-Series hardware component. You want to determine the location of the failed component and understand the potential recovery actions.
In this scenario, which tool would you use to accomplish this task?

• A.performance monitor
• B.Host Mappings tab
• C.Recovery Guru
• D.unreadable sectors log

Comment: *

Name: *

Email: *

Verification: *

What is the first step when replacing a FRU component on a running storage system? (Choose the best answer.)

• A.Disconnect the cables from the management ports.
• B.Remove the part and check SANtricity for continuing errors.
• C.Power down the array before changing the part.
• D.Use SANtricity to view the target component and place the component off-line or in service mode before removing the part.

Comment: *

Name: *

Email: *

Verification: *

What is the minimum number of drives needed to create a Dynamic Disk Pool?

• A.3
• B.8
• C.11
• D.12

Comment: *

Name: *

Email: *

Verification: *

The decision to use FC or iSCSI on the 5500 Controller with a 4-port 16Gb/s FC or 10Gb/s iSCSI Optical SFP+ HIC (Host Interface Card) can be ___________. (Choose the best answer.)

• A.changed at any time by SANtricity
• B.set at the factory, based on the order
• C.ignored because both can be used at the same time
• D.based upon the SFP type

Comment: *

Name: *

Email: *

Verification: *

Which scenario is allowed for mirroring between sites?

• A.Data Assurance disabled on the primary volume and enabled on the secondary volume
• B.FDE disabled on the primary volume and enabled on the secondary volume
• C.Data Assurance enabled on the primary volume and enabled on the secondary volume
• D.FDE enabled on the primary volume and disabled on the secondary volume

Comment: *

Name: *

Email: *

Verification: *