You are designing a new 4-node AFF A400 SAN cluster with 20 ISCSI hosts. Each AFF A400 node will have four data LIFs. Each ISCSI host needs to access every LUN over two LIFs per node on every SAN node.
In this scenario, which Netapp SAN feature enable this connectivity?

• A.Port sets
• B.HBA queue depth
• C.Selective LUN mapping
• D.Asymmetric namespace

Comment: *

Name: *

Email: *

Verification: *

When running diagnostic tests after an initial installation of a NetApp FAS3000 storage system, which command is used to run a comprehensive set of diagnostic tests on the entire system?

• A.stress
• B.comprehensive
• C.full
• D.all

Comment: *

Name: *

Email: *

Verification: *

A customer is expanding an ONTAP 9.4 switchless 2-node FAS2750 cluster. Two AFF A220 nodes will be added to the cluster.
In addition to the cluster nodes, what else is required to perform the cluster expansion?

• A.Cluster switches are required.
• B.Additional DS224C shelves are needed.
• C.Additional management switches are required.
• D.An upgrade to ONTAP 9.5 is required.

Comment: *

Name: *

Email: *

Verification: *

Click the Exhibit button.

You have a 2-node cluster in a single-fabric SAN. Host 1 and Host 2 are part of a VMware cluster and access the same LUNs that reside in your NetApp storage.
Referring to the exhibit, what would be a way to test whether the multipathing is properly configured in your environment?

• A.Administratively set ports 0a and 0c on Controller 1 to the offline setting.
• B.Disconnect Host 1 port and verify whether Host 2 is still able to run the VMs.
• C.Verify whether all destination storage target ports are contained in the same zone as Host 1.
• D.Power off the SAN switch.

Comment: *

Name: *

Email: *

Verification: *

The ESX host reports inconsistent performance for iSCSI-based connectivity.
In this scenario, what would cause this problem?

• A.The flow control is enabled on the storage.
• B.The host and storage are connected to different switches.
• C.The hardware initiators were used instead of software.
• D.The flow control was disabled on the storage.

Comment: *

Name: *

Email: *

Verification: *