Free Network Appliance NS0-593 Exam Dumps Questions & Answers

You are deploying NetApp ONTAP Select. When trying to add VMware vCenter to the inventory, you receive the message shown below.
Credential authentication failed for x.x.x.x with: HostConnectionFailed In this scenario, how would you correct this problem?

• A.Change the IP address of the vCenter server.
• B.Change the gateway address of the ONTAP Select Deploy VM.
• C.Change the IP address of the ONTAP Select Deploy VM.
• D.Change the vCenter password.

After a motherboard replacement on a NetApp AFF A300 in a SAN environment, the customer states that ports 0e and 0f are unable to connect to the fabric. The ports report "offline".
What would you examine first to troubleshoot the issue?

• A.vserver fcp wwpn-alias show command output
• B.vserver fcp interface show command output
• C.system node hardware unified-connect show command output
• D.storage port show command output

Your customer complains that u host will constantly report losing a connection to the iSCSl target and then report that the session was reestablished.

As shown in the exhibit, what is a cause of this flapping?

• A.A host with an IP address of 172.20.10.80 and a second IP address of 10.10.20.60 is accessing different LUNs.
• B.A host with an IP address of 172.20.10.80 and a second host with an IP address of 10.10.20.60 are accessing the same LUN.
• C.A host with an IP address of 172.20.10.80 and a second host with an IP address of 10.10.20.60 have the same IQN.
• D.A host with an IP address of 172.20.10.80 and a second host with an IP address of 10.10.20.60 are in different initiator groups.

You receive the panic message shown in the exhibit.

In this scenario, which component should you troubleshoot first?

• A.the CPU
• B.the MetroCluster FC-Vl card in slot 6
• C.the PCI card in slot 3
• D.the memory module in slot 1

After a normal power down of both nodes for building maintenance, Node01 of a 2-node cluster cannot be powered back up; however, all disk shelves are powered.
Which action should be performed to bring the cluster online and allow Node02 to serve data?

• A.Reboot the node With the system node reboot -node Node02 -bypass-optimization true command.
• B.Perform a takeover with the storage failover takeover -ofnode Node01 -option force command.
• C.Recreate the cluster with the system configuration recovery cluster recreate -from node command.
• D.Reinitialize the cluster with option 4a from the boot menu.