You recently discovered the error message shown below in your ONTAP logs.

What should be your first action to correct this Issue?

• A.Power cycle all the disk storage shelves that contain drives of the aggregate with the my_data_vol
  volume.
• B.Determine the root cause behind the inconsistency before attempting any recovery procedure.
• C.Use the wafliron command against my_data_vol to solve the inconsistency on the volume.
• D.Use the storage takeover command on the storage controller that contains my_data_vol.

Comment: *

Name: *

Email: *

Verification: *

You want to assign storage access to an NVMe protocol host.
Which three objects must beconfigured to accomplish this task? (Choose three.)

• A.the NVMe broadcast domain
• B.the NVMe subsystem
• C.an NVMe LIF
• D.an NVMe LUN
• E.the NVMe namespace

Comment: *

Name: *

Email: *

Verification: *

Your customer installed the shelf firmware for their NS224 shelf over a week ago, and the firmware has
notupgraded on shelf 1 module B. The customer wants to know what the next steps would be to get the
firmware upgraded after verifying that the shelf firmware is indeed loaded onto the system.
Which step would you perform to complete the firmware upgrade?

• A.Reseat the NSM100 module.
• B.Reseat the PSU of the shelf.
• C.Reseat the disk in Bay 0.
• D.Power cycle the shelf.

Comment: *

Name: *

Email: *

Verification: *

You notice poor performance on your FlexGroup and execute the system node run -node * flexgroup show
command for more Information. You notice the "Urge" column has non-zero values.
In this scenario, which statement is true?

• A.The constituent volumes are out ofInodes.
• B.The aggregate is completely full.
• C.The data placement is uneven.
• D.The constituent volumes are completely full.

Comment: *

Name: *

Email: *

Verification: *

After expanding a two-node AFF A300 cluster with two AFF A700 nodes, you observe latencies when data is
accessed indirectly. The system node run -node -command netstat command shows retransmits and packet
drops on the LIFs. The AFF A700 nodes with 40 Gbps and the AFF A300 connect with 10 Gbps to the cluster
interconnect. You are using Cisco Nexus 3132Q cluster interconnect switches. You just updated to ONTAP
9.8 software.
In this scenario, what is causing this problem?

• A.The AFF A300 Is using an adapter card for the cluster Interconnect, but only onboard ports are supported.
• B.AFF A300 and AFF A700 node mixing Isnot supported in ONTAP 9.8 software.
• C.There is an NXOS firmware mismatch, verify in the Interoperability Matrix (1MTJ for a supportedversion.
• D.The 10 Gbps to 10 Gbps cluster Interconnect is creating a speed mismatch.

Comment: *

Name: *

Email: *

Verification: *