A consultant configures an ESXi cluster which will utilize a vSphere Distributed Switch (vDS). The consultant has just migrated the first host to the dvSwitch when several alerts appear within Prism Element regarding Host-to-CVM connectivity.
What is causing these alerts?

• A.The consultant migrated the CVM svm-iscsi-pg network adapter over to the vDS.
• B.VLAN tags are incorrectly configured on the vDS port groups.
• C.The consultant migrated the CVM Backplane and VM network adapter over to the vDS.
• D.The consultant migrated the CVM Backplane network adapter over to the vDS.

Comment: *

Name: *

Email: *

Verification: *

A consultant finishes creating a new ESXi cluster. The consultant connects to the nodes via laptop and a personal flat switch. The host/CVM network is on VLAN 23. The customer has the native VLAN on the ToR switches set to 23.
The customer wants to use LACP. Before placing the nodes on the customer network, the consultant tags VLAN 23 for each host and CVM. The consultant connects the nodes to the customer network and finds that they are unreachable.
What is causing this issue?

• A.The host and CVM are incorrectly configured.
• B.Under the vSwitch0 settings, the consultant did not select Route based on IP hash.
• C.The hosts have not been migrated to a vSphere Distributed Switch.
• D.The customer has LACP fallback enabled on switch ports.

Comment: *

Name: *

Email: *

Verification: *

An administrator iscurrently using both 10g uplink with LACP and balance-tcp. A single VM should not be allowed to use more than a single 10G uplink, and both uplinks should be utilized.
Which two command should be used to configure the bond? (choose two)

• A.Ovs-vsctl set port br0-up other_config: bond-rebalance-interval=30000
• B.Ovs-vsctl set port br0-up bond_mode=balance-tcp
• C.Ovs-vsctl set port br0-up bond_mode=active-backup
• D.Ovs-vsctl set port br0-up bond_mode=balance-slb

Comment: *

Name: *

Email: *

Verification: *

Which two components must be identified to validate that software compatibility requirements are met for Nutanix Cluster Installation? (Choose two.)

• A.Guest OS
• B.Hypervisor
• C.AOS
• D.Firmware

Comment: *

Name: *

Email: *

Verification: *

An administrator needs to make sure an RF3 cluster can survive a failure of two complete racks without negatively affecting performance. The current cluster configuration consists of the following:
* 30 All Flash Nodes: distributed 10 nodes per rack across three 42U racks
* Each node is configured with 20TB usable storage all flash (Cluster Total 600TB Usable)
* Current cluster utilization is 500TB storage
* Storage containers have Erasure Coding enabled
Which configuration changes should be made to make sure the cluster meets the requirements?

• A.Expand the cluster to 50 nodes distributed evenly across 5 racks
• B.Expand the cluster to 48 nodes distributed evenly across 6 racks
• C.Expand the cluster to 60 nodes distributed evenly across 6 racks
• D.Expand the cluster to 40 nodes distributed evenly across 5 racks

Correct Answer: C

Explanation
Ref:https://portal.nutanix.com/page/documents/details?targetId=Web-Console-Guide-Prism-v5_17:arc-configure

Comment: *

Name: *

Email: *

Verification: *