Free Oracle 1Z0-879 Exam Dumps Questions & Answers


Exam Code/Number:	1Z0-879Join the discussion
Exam Name:	Oracle Solaris 10 System Administrator Certified Professional Upgrade Exam
Certification:	Oracle
Free Question Number:	612
Publish Date:	Aug 10, 2026
# of views:	2154
Rating 100%

Page: 1 / 123
Total 612 questions

Question 1

You have setup the following ZFS file systems:

You want to limit the amount of disk space that the /data/pool/web file system can consume. Which command would set the limit for the /data/pool/web file system so that it would consume no more than 2GB of disk space?

A.zfs set quota -2G datapool/web
B.set zfs quota 2G datapool/web
C.quota datapool/web 2G
D.zfs set quota=2G datapool/web

Question 2

During boot up, your x86-based laptop that is running the Solaris 10 OS displays the message:
NFS server arizona not responding, still trying
Which two are valid troubleshooting procedures for this problem? (Choose two.)

A.verify that the nfsd daemon is running on your laptop
B.verify that the NFS client entry in /etc/inetd.conf is correct, then get inetd to reread the /etc/inetd.conf
C.verify that the server arizona is up and that its network interface is up.
D.restart the NFS client-side daemons
E.verify that your laptop is connected to the correct network

Question 3

Which of the following provides the JumpStart client with the location of the system identification file? (Choose two.)

A.The system identification file is always located in the /export/config directory.
B.Specified by the setup_install_server command.
C.Specified by the add_install_client command.
D./etc/bootparams file
E.Name Service

Question 4

Which two statements are true about the inetd process on a system running the Solaris 10 OS? (Choose two.)

A.It only runs on servers.
B.It is considered the master restarter.
C.It consults /etc/inet/services to determine which service to start when a request is received on a port.
D.It starts well-known services on demand that are NOT automatically started at boot time.

Question 5

You are setting up a Sun server with two internal SATA disk drives. You have also installed two PCI SCSI controllers, and have installed four SCSI disk drives on each controller. Now you want to check that all of the hardware is configured properly and that all of the hard drives are visible by the system. Which Open Boot command(s) are used to verify that all of the drives are accessible and that the server is able to identify all of the disk drives?

A.probe-all
B.probe-scsi-all followed by probe-ide-all
C.probe-scsi followed by probe-ide
D.sifting probe