Free Oracle 1z1-404 Exam Dumps Questions & Answers

To ensure proper operation of a Session Border Controller HighAvailability (HA) pair, it is critical that both of the devices can originate legitimate traffic on media interfaces independent of the network interface IP address.
How is this type of traffic accommodated?

• A.by setting a unique address on the wancoml and wancom2 interfaces via the utilityaddress command
• B.by setting the pri-utility-addr, sec-utility-addr, and sec-gateway values to addresses in the same subnet as the IP address configured on the management interfaces
• C.by setting the pri-utility-addr, sec-utility-addr, and sec-gateway values to addresses in the same subnet as the IP address configured on the media interfaces
• D.via the utility address parameters on the wancoml and wancom2 interfaces
• E.by setting the utility address and sec-gateway values to addresses in different subnets as the IP address configured on the wancom interfaces

Which configuration step is required to route a SIP callbased on the value of the SIP
INVITE Request-URI?

• A.Navigate to the policy-attribute configuration element and configure the from-address parameter to match the Request-URI value.
• B.Navigate to the policy-attribute configuration element and configure the to-address parameter to match the Request-URI value.
• C.Navigate to the local-policy configuration element and configure the to-address parameter to match the Request-URI value.
• D.Navigate to the local-policy configuration element and configure the destination-address parameter to match the Request-URI value.
• E.Navigate to the local-policy configuration element and configure the from-address parameter to match the Request-URI value.

Which three statements are true about the bootloader? (Choose three.)

• A.It is a Windriver's VxWork product
• B.It decompresses the image file and loads it into the main RAM
• C.It reads the imagefile
• D.It looks at the boot parameters
• E.It is based on Linux

What is the first thing you should do when you want the Session Border Controller to detect that anendpoint is behind a NAT/firewall device?

• A.Navigate to the sip-interface configuration element and set the nat-traversal parameter to never.
• B.Navigate to the sip-interface configuration element and set the nat-traversal parameter to detect.
• C.Navigate to the sip-port configuration element and set the nat-traversal parameter to enabled.
• D.Navigate to the sip-port configuration element and set the nat-traversal parameter to disabled.
• E.Navigate to the sip-interface configuration element and set the nat-traversal parameter to always.

You need to configure the Session Border Controller toperform load balancing between two downstream SIP proxies.
Which option shows the configuration elements that you should configure for the load balancing feature?

• A.session-router and router-group
• B.group-policy andload-policy
• C.local-policy and session-group
• D.proxy and proxy-pool
• E.realm-config and enum-group