Which of the following stages can be modeled using scenarios from the S&OP planning cycle? Note:
There are 2 correct Answers to this question.

• A.Data input review for inventory
• B.Demand review
• C.Demand sensing stage
• D.Demand-supply balancing

Comment: *

Name: *

Email: *

Verification: *

Which are the mandatory preconditions for an attribute that can be used for saving the segmentation results?
Note: There are 2 correct Answers to this question.

• A.It should be a non-key attribute of the master data type.
• B.Its data type is INTEGER and its length has been specified.
• C.It belongs to a simple or compound master data type.
• D.The length of the attribute needs to be 18 digits.

Comment: *

Name: *

Email: *

Verification: *

You are working with the inventory optimization process and you want to use a what-if analysis. What parameters are assessed by this analysis? Note: There are 2 correct Answers to this question.

• A.Service levels
• B.Changed variability
• C.Capacity consumption
• D.Number of planning combinations

Comment: *

Name: *

Email: *

Verification: *

Which conditions are prerequisites for key figure disaggregation?

• A.The key figure is calculated and editable.
• B.The key figure is calculated and aggregation mode is selected.
• C.The key figure is set to Not Editable.
• D.The key figure is stored and editable.

Comment: *

Name: *

Email: *

Verification: *

You are adding a value-based filter to a planning view. Which of the following conditions apply? Note:
There are 3 correct Answers to this question.

• A.You can add (or delete) planning objects to a planning view after these filters are applied.
• B.These filters can be used together with attribute totals in the same planning view.
• C.You can only apply one value-based filter per planning view.
• D.The alerts dashboard is not available if a value-based filter is set for the open planning view.
• E.These filters are always applied based on the values stored in the database.

Comment: *

Name: *

Email: *

Verification: *