Often inspection stations do not require full time presence. A usual practice is to collect such stations into a __________ so designed that it will occupy the full time of one person.
Response:

• A.100% inspection
• B.Spot check
• C.Patrol beat
• D.Round robin

Comment: *

Name: *

Email: *

Verification: *

An aerial tower lift truck has just arrived at the inspector's shop to review a craze in the filament wound composite on the bottom side of the boom to see if there is hazardous structural damage. The center of the craze is 35 feet from the bucket. The inspector has to measure the maximum diameter of the craze.
The caliper is dimensioned in millimeters. The maintenance chart is given here:


What classification should the inspector provide for this boom damage? Response:

• A.None of the above. The graph does not cover the region and craze size observed.
• B.Minor
• C.Major
• D.Critical

Comment: *

Name: *

Email: *

Verification: *

A telescopic gage is best described in which of the following ways?
I) It is a calibrated instrument.
II) It is used for transfer measurement.
III) It is used for inside measurement.
Response:

• A.I only
• B.I and II only
• C.II and III only
• D.III only

Comment: *

Name: *

Email: *

Verification: *

As a precaution when using torque wrenches:
Response:

• A.Never extend the torque wrench
• B.Ensure the extension is 90 degrees to avoid cosine error
• C.Hold the handle at a comfortable position
• D.Apply the force slowly and smoothly

Comment: *

Name: *

Email: *

Verification: *

In general terms, a highly capable process is when the spread of the process is:
Response:

• A.The same as the specification limits
• B.Equal to or greater than the control limits
• C.Substantially less than the specification limits
• D.Substantially less than the control limits

Comment: *

Name: *

Email: *

Verification: *