Instant Access Cisco.200-301.v2022-02-08.q216 Actual Practice Test Engine for Free (Page 36)

Question 171

While examining excessive traffic on the network, it is noted that all incoming packets on an interface appear to be allowed even though an IPv4 ACL is applied to the interface. Which two misconfigurations cause this behavior? (Choose two.)

A.A matching deny statement is too high in the access list
B.The packets fail to match any permit statement
C.A matching permit statement is too broadly defined
D.The ACL is empty
E.A matching permit statement is too high in the access list

Question 172

Drag and drop the Cisco Wireless LAN Controller security settings from the left onto the correct security mechanism categories on the right.

Question 173

A cisco router is booting and has just completed the POST process. It is now ready to find and load an IOS image.
What function does the router perform next?

A.It inspects the configuration file in NVRAM for boot instructions
B.It loads the first image file in flash memory
C.It attempts to boot from a TFTP server
D.It checks the configuration register

Question 174

For what two purposes does the Ethernet protocol use physical addresses?

A.to differentiate a Layer 2 frame from a Layer 3 packet
B.to uniquely identify devices at Layer 2
C.to allow detection of a remote device when its physical address is unknown
D.to allow communication with devices on a different network
E.to establish a priority system to determine which device gets to transmit first
F.to allow communication between different devices on the same network

Question 175

Refer to the exhibit.

Which outcome is expected when PC_A sends data to PC_B?

A.The source and destination MAC addresses remain the same.
B.The source MAC address is changed.
C.The destination MAC address is replaced with ffff.ffff.ffff.
D.The switch rewrites the source and destination MAC addresses with its own.

Question 171

Question 172

Question 173

Question 174

Question 175

Download PDF File