Refer to the exhibit. An extended ACL has been configured and applied to router R2 The configuration farted to work as intended.
Which two changes stop outbound traffic on TCP ports 25 and 80 to 10.0.20.0/26 from the 10.0.10 0/26 subnet while still allowing all other traffic? (Choose two)

• A.The ACL must be configured the Gi0/2 interface in bound on R1
• B.Add a "permit ip any any" statement at the end of ACL 101 for allowed traffic
• C.Add a "permit ip any any" statement to the beginning of ACL 101 for allowed traffic.
• D.The ACL must be moved to the Gi0/1interface outbound onR2
• E.The source and destination IPs must be swapped in ACL 101

Comment: *

Name: *

Email: *

Verification: *

Refer to the graphic. R1 is unable to establish an OSPF neighbor relationship with R3. What are possible reasons for this problem? (Choose two.)

• A.All of the routers need to be configured for backbone Area 1.
• B.R1 and R2 are the DR and BDR, so OSPF will not establish neighbor adjacency with R3.
• C.A static route has been configured from R1 to R3 and prevents the neighbor adjacency from being established.
• D.The hello and dead interval timers are not set to the same values on R1 and R3.
• E.EIGRP is also configured on these routers with a lower administrative distance.
• F.R1 and R3 are configured in different areas.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which configuration issue is preventing the OSPF neighbor relationship from being established between the two routers?

• A.R1 interface Gil/0 has a larger MTU size
• B.R2 should have its network command in area 1
• C.R2 is using the passive-interface default command
• D.R1 has an incorrect network command for interface Gi1/0

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which two statements are true about inter VLAN routing in the topology that is shown in the exhibit? (Choose two.)

• A.The FastEthernet 0/0 interface on Router1 must be configured with subinterfaces
• B.The FastEthernet 0/0 interface on Router1 and Switch2 trunk ports must be configured using the same encapsulation type
• C.Host E and host F use the same IP gateway address.
• D.Router1 will not play a role in communications between host A and host D.
• E.Router1 needs more LAN interfaces to accommodate the VLANs that are shown in the exhibit.
• F.Router1 and Switch2 should be connected via a crossover cable.

Comment: *

Name: *

Email: *

Verification: *

Router A learns the same route from two different neighbors, one of the neighbor routers is an OSPF neighbor and the other is an EIGRP neighbor.
What is the administrative distance of the route that will be installed in the routing table?

• A.20
• B.90
• C.110
• D.115

Comment: *

Name: *

Email: *

Verification: *