What is a function of a Layer 3 switch?

• A.transmit broadcast traffic when operating in Layer 3 mode exclusively
• B.move frames between endpoints limited to IP addresses
• C.flood broadcast traffic within a VLAN
• D.forward Ethernet frames between VLANs using only MAC addresses

Comment: *

Name: *

Email: *

Verification: *

Which two primary drivers support the need for network automation? (Choose two.)

• A.Reducing hardware footprint
• B.Eliminating training needs
• C.Policy-derived provisioning of resources
• D.Increasing reliance on self-diagnostic and self-healing
• E.Providing a ship entry point for resource provisioning

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which change to the configuration on Switch?
allows the two switches to establish an GtherChannel?

• A.Change the protocol to PAqP and use auto mode
• B.Change the LACP mode to desirable
• C.Change the LACP mode to active
• D.Change the protocol to EtherChannel mode on.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. An engineer must add a subnet for a new office that will add 20 users to the network. Which IPv4 network and subnet mask combination does the engineer assign to minimize wasting addresses?

• A.10.10.225.32 255.255.255.240
• B.10.10.225.48 255.255.255.224
• C.10.10.225.48 255.255.255.240
• D.10.10.225.32 255.255.255.224

Comment: *

Name: *

Email: *

Verification: *

Where does the configuration reside when a helper address Is configured lo support DHCP?

• A.on every router along the path
• B.on the router closest to the server
• C.on the switch trunk interface
• D.on the router closest to the client

Comment: *

Name: *

Email: *

Verification: *