An engineer is asked to protect unused ports that are configured in the default VLAN on a switch.
Which two steps will fulfill the request? (Choose two)

• A.Configure the port type as access and place in VLAN 99
• B.Configure the ports in an EtherChannel.
• C.Administratively shut down the ports
• D.Enable the Cisco Discovery Protocol
• E.Configure the ports as trunk ports

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

When PC-A sends traffic to PC-B, which network component is in charge of receiving the packet from PC-A verifying the IP addresses, and forwarding the packet to PC-B?

• A.Router
• B.Layer 2 switch
• C.firewall
• D.Load balancer

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

If configuring a static default route on the router with the ip route 0.0.0.0 0.0.0.0 10.13.0.1 120 command how does the router respond?

• A.It ignores the new static route until the existing OSPF default route is removed
• B.It immediately replaces the existing OSPF route in the routing table with the newly configured static route
• C.It starts load-balancing traffic between the two default routes
• D.It starts sending traffic without a specific matching entry in the routing table to GigabitEthernetO/1

Comment: *

Name: *

Email: *

Verification: *

Drag the descriptions of device management from the left onto the types of device management on the right.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

A Cisco IP phone receive untagged data traffic from an attached PC. Which action is taken by the phone?

• A.It allows the traffic to pass through unchanged
• B.It drops the traffic
• C.It tags the traffic with the default VLAN
• D.It tags the traffic with the native VLAN

Comment: *

Name: *

Email: *

Verification: *