Which command enables a router to become a DHCP client?

• A.ip address dhcp
• B.ip helper-address
• C.ip dhcp pool
• D.ip dhcp client

Comment: *

Name: *

Email: *

Verification: *

Two switches are connected and using Cisco Dynamic Trunking Protocol SW1 is set to Dynamic Desirable What is the result of this configuration?

• A.The link is becomes an access port.
• B.The link becomes a trunk port.
• C.The link is in a down state.
• D.The link is in an error disables state

Comment: *

Name: *

Email: *

Verification: *

How does HSRP provide first hop redundancy?

• A.It load-balances traffic by assigning the same metric value to more than one route to the same destination m the IP routing table.
• B.It load-balances Layer 2 traffic along the path by flooding traffic out all interfaces configured with the same VLAN.
• C.It forwards multiple packets to the same destination over different routed links n the data path
• D.It uses a shared virtual MAC and a virtual IP address to a group of routers that serve as the default gateway for hosts on a LAN

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which password must an engineer use to enter the enable mode?

• A.adminadmin123
• B.default
• C.testing 1234
• D.cisco123

Comment: *

Name: *

Email: *

Verification: *

What mechanism carries multicast traffic between remote sites and supports encryption?

• A.ISATAP
• B.GRE over iPsec
• C.iPsec over ISATAP
• D.GRE

Comment: *

Name: *

Email: *

Verification: *