Refer to the exhibit. The CE router has established a BGP peering with the PE router, and the CE will use the core infrastructure of the PE as a backbone carrier to support CSC.
Which additional task can you perform to complete the configuration?

• A.Configure static routing on the CE router.
• B.Configure the address-family ipv4 labeled-unicast command under the neighbor configuration of the CE router for the PE.
• C.Change the rd value to 65001:65001 under the VRF section of the PE router.
• D.Configure OSPF on the PE router.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Router 1 is a route reflector client within a service provider core PE1 cannot see VPNv4 routes received from the ASBR PE1 only has an iBGP relationship with Router 1. Which action resolves this issue?

• A.Configure PE1 to have an eBGP relationship with Router 1.
• B.Configure Router 1 as a route reflector for PE1 under the VPNv4 address family.
• C.Enable BGP default ipv4-unicast
• D.Activate PE1 as a neighbor under the IPv4 address family.

Comment: *

Name: *

Email: *

Verification: *

A service provider that implements large L2VPNs received a request to implement EVPN Native to improve a customer's Layer 2 communication across the core. MPLS is configured in the core to support VPN transport. Which action must the engineer take as part of the implementation?

• A.Configure MPLS TE between PEs to support MAC address learning over the core where EVPN is disabled.
• B.Configure a pseudowire between the CEs to allow for Layer 2 to be extended beyond the EVPN configuration.
• C.Configure EVPN to support IP traffic only and disable MPLS to improve efficiency.
• D.Configure the customer EVPN to advertise MAC addresses over the core.

Comment: *

Name: *

Email: *

Verification: *

The CTO of a company requires the support of a network consultant to deliver an MPLS solution without resigning to a certain degree of redundancy and scalability. Which solution effectively scales to hundreds or thousands of sites?

• A.L3VPN with direct LSP connectivity between all PEs.
• B.L3VPN using a hierarchical topology of N-PEs and U-PEs.
• C.L2VPN by encapsulating multiple frame formats with interworking.
• D.L2VPN with the broadcast traffic processed at the ingress PE.

Comment: *

Name: *

Email: *

Verification: *

Which BGP feature causes to replace the AS number of originating router with the AS number of the sending router?

• A.confederations
• B.AS override
• C.route reflectors
• D.route dampening

Comment: *

Name: *

Email: *

Verification: *