Instant Access Cisco.300-615.v2022-04-09.q100 Actual Practice Test Engine for Free (Page 6)

Question 21

Refer to the exhibit.

A network engineer configures an EEM script to get a syslog notification after a configuration change. This message appears when the engineer must make a new configuration to this switch. Which configuration did the engineer neglect to apply in the script for it to function properly?

A.event policy-default count 1 time 100
B.event cli match 'configure terminal'
C.action 2.0 event-default
D.event syslog occurs 10

Question 22

Refer to the exhibit.

The vPC between switch1 and switch2 does not work. Which two actions resolve the problem? (Choose two.)

A.Configure the IP address on the interface.
B.Activate VLANs on the vPC.
C.Configure one of the switches as primary for the vPC.
D.Correct the configuration of the vPC peer link and the vPC peer keepalive.
E.Match the vPC domain ID between the two devices.

Question 23

Refer to the exhibit. The initiator that has FC ID 0x970102 fails to communicate with the target that has FC ID
0x970200. What action resolves the issue?

A.Reconfigure the initiator and the target to be in the same zones.
B.Reactivate the zoneset.
C.Reset the port for FC ID 0x970102 and FC ID 0x970200 to log in to the fabric.
D.Reset the port for FC ID 0x970209 and FC ID 0x9700c2 to log in to the fabric.

Question 24

A customer reports that the Chassis Management Controller fails to receive chassis information from Cisco UCS Manager. Which set of steps resolves the issue?

A.1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels
2) Verify that at least two physical cables between the IOM and fabric interconnect function properly.
3) Check for runtime link down status
4) Reseat the affected IOM.
B.1) Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
2) Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
3) Check for runtime link down status
4) Reseat the affected IOM.
C.1) Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
2) Verify that at least two physical cables between the IOM and fabric interconnect function properly.
3) Check for runtime link down status.
4) Reseat the affected IOM.
D.1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels.
2) Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
3) Check for runtime link down status.
4) Reseat the affected IOM.

Question 25