A server fails to boot from the operating system after a RAID1 cluster migration. The RAID remains in an inactive state during and after a service profile association. Which action resolves the issue?

• A.Remove the local disk configuration policy.
• B.Configure the SAN boot target in the service profile.
• C.Use a predefined local disk configuration policy.
• D.Configure the SAN boot target to any configuration mode.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A client configures an upgrade of its Cisco Nexus switches that are connected to the Cisco ACI controller, such that the switches are upgraded one at a time. After the upgrade is run, it is discovered that both Cisco Nexus switches were upgraded simultaneously. Which two actions ensure that the switches upgrade one at a time? (Choose two.)

• A.Configure the *Do not pause on failure and do not wait on cluster health" Run Mode
• B.Select the "Graceful Maintenance" checkbox
• C.Choose the 'Pause upon upgrade failure" Run Mode
• D.Check the Ignore Compatibility" checkbox
• E.Place each leaf switch in a different upgrade group

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

The HSRP configuration in the exhibit fails to function. Which action resolves this issue?

• A.Set the MTU to 1500 bytes.
• B.Enable IP redirects.
• C.Configure HSRP version 2.
• D.Configure the same HSRP group on both devices.

Comment: *

Name: *

Email: *

Verification: *

An IOM fails during a firmware upgrade and is unresponsive. Which action recovers the module?

• A.Restore UCSM configuration from backup.
• B.Roll back to the previous firmware.
• C.Use AutoInstall to reinstall the firmware.
• D.From the peer IOM, reset the faulty module.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. A PC belongs to VLAN 68. The user experiences a large amount of packet loss when communicating with hosts that are outside of VLAN 68. Which action resolves the problem?

• A.Replace HSRP with GLBP.
• B.Remove the HSRP configuration.
• C.Enable the peer-gateway feature.
• D.Configure ip arp synchronization on both switches.

Comment: *

Name: *

Email: *

Verification: *