Instant Access Cisco.350-401.v2022-05-12.q177 Actual Practice Test Engine for Free (Page 36)

Question 171

Reter to the exhibit.

Refer to the exhibit. Which python code parses the response and prints "18:32:21.474 UTC sun Mar 10 2019?

A.print(response['body']['simple_time']}
B.print(response['resut'][0||'simple_time']}
C.print(response[result']['body']['simple_time']}
D.print(response[jresult']['body']['simple_time']}

Question 172

Why would an engineer use YANG?

A.to transport data between a controller and a network device
B.to access data using SNMP
C.to translate JSON into an equivalent XML syntax
D.to model data for NETCONF

Question 173

Refer to the exhibit.

An engineer must ensure that all traffic leaving AS 200 will choose Link 2 as an entry point. Assuming that all BGP neighbor relationships have been formed and that the attributes have not been changed on any of the routers, which configuration accomplish task?

A.Option A
B.Option B
C.Option C
D.Option D

Question 174

Refer to the exhibit. An engineer attempts to configure a trunk between switch sw1 and switch SW2 using DTP, but the trunk does not form. Which command should the engineer apply to switch SW2 to resolve this issue?

A.switchport mode dynamic desirable
B.switchport mode access
C.no switchport
D.switchport nonegotiate

Question 175

Which Cisco FlexConnect state allows wireless users that are connected to the network to continue working after the connection to the WLC has been lost?

A.Authentication Down/Switching Down
B.Authentication-Central/Switch-Local
C.Authentication- Down/Switch-Local
D.Authentication-Central/Switch-Central

Correct Answer: C

Operation Modes
There are two modes of operation for the FlexConnect AP.
Connected mode: The WLC is reachable. In this mode the FlexConnect AP has CAPWAP connectivity with its WLC.
Standalone mode: The WLC is unreachable. The FlexConnect has lost or failed to establish CAPWAP connectivity with its WLC. A WAN-link outage between a branch and its central site is a example of such a mode of operation.
FlexConnect States
A FlexConnect WLAN, depending on its configuration and network connectivity, is classified as being in one of the following defined states.
Authentication-Central/Switch-Central: This state represents a WLAN that uses a centralized authentication method such as 802.1X, VPN, or web. User traffic is sent to the WLC via CAPWAP (Central switching). This state is supported only when FlexConnect is in connected mode.
Authentication Down/Switching Down: Central switched WLANs no longer beacon or respond to probe requests when the FlexConnect AP is in standalone mode. Existing clients are disassociated.
Authentication-Central/Switch-Local: This state represents a WLAN that uses centralized authentication, but user traffic is switched locally. This state is supported only when the FlexConnect AP is in connected mode.
Authentication-Down/Switch-Local: A WLAN that requires central authentication rejects new users. Existing authenticated users continue to be switched locally until session time-out if configured. The WLAN continues to beacon and respond to probes until there are no more existing users associated to the WLAN. This state occurs as a result of the AP going into standalone mode.
Authentication-local/switch-local: This state represents a WLAN that uses open, static WEP, shared, or WPA2 PSK security methods. User traffic is switched locally. These are the only security methods supported locally if a FlexConnect goes into standalone mode. The WLAN continues to beacon and respond to probes. Existing users remain connected and new user associations are accepted. If the AP is in connected mode, authentication information for these security types is forwarded to the WLC.

Question 171

Question 172

Question 173

Question 174

Question 175

Download PDF File