Refer to the exhibit.

Which action resolves the EtherChannel issue between SW2 and SW3?

• A.Configure channel-group 1 mode active on both interfaces.
• B.Configure channel-group 1 mode desirable on both interfaces.
• C.Configure switchport nonegotiate on SW3
• D.Configure switchport mode trunk on SW2.

Comment: *

Name: *

Email: *

Verification: *

Drag and drop the tools from the left onto the agent types on the right.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

An administrator must enable Telnet access to Router X using the router username and password database for authentication. Which configuration should be applied?
A)

B)

C)

D)

• A.Option A
• B.Option B
• C.Option C
• D.Option D

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer must block all traffic from a router to its directly connected subnet 209.165.200.0/24. The engineer applies access control list EGRESS in the outbound direction on the GigabitEthernet0/0 interface of the router However, the router can still ping hosts on the 209.165.200.0/24 subnet. Which explanation of this behavior is true?

• A.Access control lists that are applied outbound to a router interface do not affect traffic that is sourced from the router.
• B.The access control list must contain an explicit deny to block traffic from the router.
• C.After an access control list is applied to an interface, that interface must be shut and no shut for the access control list to take effect.
• D.Only standard access control lists can block traffic from a source IP address.

Comment: *

Name: *

Email: *

Verification: *

Which devices does Cisco DNA Center configure when deploying an IP-based access control policy?

• A.All devices integrating with ISE
• B.selected individual devices
• C.all devices in selected sites
• D.all wired devices

Comment: *

Name: *

Email: *

Verification: *