Refer to the exhibit. Rapid PVST+ is enabled on all switches. Which command set must be configured on switch1 to achieve the following results on port fa0/1?

A)

B)

C)

D)

• A.Option A
• B.Option C
• C.Option D
• D.Option B

Comment: *

Name: *

Email: *

Verification: *

A vulnerability assessment highlighted that remote access to the switches is permitted using unsecure and unencrypted protocols Which configuration must be applied to allow only secure and reliable remote access for device administration?

• A.line vty 0 15
  login local
  transport input none
• B.line vty 0 15
  login local
  transport input telnet ssh
• C.line vty 0 15
  login local
  transport input ssh
• D.line vty 0 15
  login local
  transport input all

Comment: *

Name: *

Email: *

Verification: *

Which measurement is used from a post wireless survey to depict the cell edge of the access points?

• A.SNR
• B.Noise
• C.RSSI
• D.CCI

Comment: *

Name: *

Email: *

Verification: *

An engineer is configuring a new SSID to present users with a splash page for authentication. Which WLAN Layer 3 setting must be configured to provide this functionally?

• A.Local Policy
• B.WPA2 Policy
• C.CCKM
• D.Web Policy

Comment: *

Name: *

Email: *

Verification: *

An engineer is implementing a Cisco MPLS TE tunnel to improve the streaming experience for the clients of a video-on-demand server. Which action must the engineer perform to configure extended discovery to support the MPLS LDP session between the headend and tailend routers?

• A.Configure an access list on the interface to permit TCP and UDP traffic
• B.Configure a targeted neighbor session.
• C.Configure the interface bandwidth to handle TCP and UDP traffic between the LDP peers
• D.Configure a Cisco MPLS TE tunnel on both ends of the session

Comment: *

Name: *

Email: *

Verification: *