Refer to the exhibit. An engineer configures CoPP and enters the show command to verify the implementation.
What is the result of the configuration?

• A.If traffic exceeds the specified rate, it will be transmitted and remarked.
• B.ICMP will be denied based on this configuration.
• C.Class-default traffic will be dropped.
• D.All traffic will be policed based on access-list 120.

Comment: *

Name: *

Email: *

Verification: *

An engineer is working with the Cisco DNA Center API Drag and drop the methods from the left onto the actions that they are used for on the right.

Correct Answer:

Explanation

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which IPv6 OSPF network type is applied to interface Fa0/0 of R2
by default?

• A.multipoint
• B.broadcast
• C.Ethernet
• D.point-to-point

Comment: *

Name: *

Email: *

Verification: *

How does the EIGRP metric differ from the OSPF metric?

• A.The EIGRP metric is calculated based on bandwidth only. The OSPF metric is calculated on delay only.
• B.The EIGRP metric is calculated based on delay only. The OSPF metric is calculated on bandwidth and delay.
• C.The EIGRP metric Is calculated based on bandwidth and delay. The OSPF metric is calculated on bandwidth only.
• D.The EIGRP metric Is calculated based on hop count and bandwidth. The OSPF metric is calculated on bandwidth and delay.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A GRE tunnel has been created between HO and BR routers.
What is the tunnel IP on the HQ router?

• A.10.111.111.1
• B.10.111.111.2
• C.209.165.202.130
• D.209.165.202.134

Correct Answer: A

Explanation
In the above output, the IP address of "209.165.202.130" is the tunnel source IP while the IP 10.111.1.1 is the tunnel IP address.
An example of configuring GRE tunnel is shown below:

Comment: *

Name: *

Email: *

Verification: *