Which function is handled by vManage in the Cisco SD-WAN fabric?

• A.Distributes policies that govern data forwarding
• B.Establishes IPsec tunnels with nodes.
• C.Establishes BFD sessions to test liveliness of links and nodes
• D.Performs remote software upgrades for WAN Edge. vSmart and vBond

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A network administrator configured RSPAN to troubleshoot an issue between switchl and switch2. The switches are connected using interface GigabitEthernet 1/1 An external packet capture device is connected to swich2 interface GigabitEthernet1/2 Which two commands must be added to complete this configuration?
(Choose two)

• A.switch2(config)# monitor session 1 source remote vlan 70 switch2(config)# monitor session 1 destination interface GigabitEthernet1/2
• B.switch1(config)# interface GigabitEthernet 1/1 switch1(config-if)# switchport mode access switch1(config-if)# switchport access vlan 10 switch2(config)# interface GigabitEthernet 1/1 switch2(config-if)# switchport mode access switch2(config-if)# switchport access vlan 10
• C.switch2(config)# monitor session 2 destination vlan 10
• D.switch2(config)# monitor session 1 source remote vlan 70 switch2(config)# monitor session 1 destination interface GigabitEthernet1/1
• E.switch2(config-if)# switchport trunk allowed vlan 10,20,30,40,50,60,70-80

Comment: *

Name: *

Email: *

Verification: *

Why would a log file contain a * next to the date?

• A.The network device is not configured to use NTP time stamps for logging.
• B.The network device is not configured to use NTP
• C.The network device was unable to reach the NTP server when the log messages were recorded.
• D.The network device was receiving NTP time when the log messages were recorded

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

What is the result of the API request?

• A.The Information for all interfaces is read from the network appliance.
• B.The native interface information is read from the network appliance.
• C.The "params" variable reads data fields from the network appliance
• D.The "params" variable sends data fields to the network appliance.

Comment: *

Name: *

Email: *

Verification: *

A network engineer is adding an additional 10Gps link to an exiting 2x10Gps LACP-based LAG to augment its capacity. Network standards require a bundle interface to be taken out of service if one of its member links goes down, and the new link must be added with minimal impact to the production network. Drag and drop the tasks that the engineer must perform from the left into the sequence on the right. Not all options are used.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *