Drag and drop the functions from the left onto the correct Path Computation Element Protocol roles on the right

Path Computation Element (Calculates paths through the network, keeps TE topology database information, sends path status updates) Path computation Client (sends path calculation request, sends path creation request) Path Computation Element (PCE) Represents a software module (which can be a component or application) that enables the router to compute paths applying a set of constraints between any pair of nodes within the router's TE topology database. PCEs are discovered through IGP.
Path Computation Client (PCC)
Represents a software module running on a router that is capable of sending and receiving path computation requests and responses to and from PCEs. The PCC is typically an LSR (Label Switching Router).
https://www.cisco.com/c/en/us/td/docs/routers/crs/software/crs_r5-3/mpls/configuration/guide/b-mpls-cg53x-crs/b-mpls-cg53x-crs_chapter_0110.html#con_1279822

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

A customer of an ISP requests support to setup a BGP routing policy. Which BGP attribute should be configured to choose specific BGP speakers as preferred points for the customer AS?

• A.lowest multi-exit discriminator
• B.highest local preference outbound
• C.lowest local preference inbound
• D.highest local preference inbound

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. Router 1 is missing the route for the router 2 loopback 0. What should the engineer change to fix the problem?

• A.Router 1 to be an ABR
• B.the wildcard mask network statement in OSPF of Router 2
• C.the hello timers on Router 1 and Router 2 to be different
• D.the area numbers on Router 1 and Router 2 to be similar

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit:

Assume all other configurations are correct and the network is otherwise operating normally. Which conclusion can you draw about the neighbor relationship between routers R1 and R2?

• A.The neighbor relationship will be up only if the two devices have activated the correct neighbor relationships under the IPv4 address family
• B.The neighbor relationship is down because the loco I-as value for R2 is missing in the R1 neighbor statement
• C.The neighbor relationship is down because R1 believes R2 is in AS 65012.
• D.The neighbor relationship is up

Comment: *

Name: *

Email: *

Verification: *

Which MPLS design attribute can you use to provide Internet access to a major customer through a separate dedicated VPN?

• A.The CE router supports VRF-Ute and the full BGP routing table.
• B.The Internet gateway inserts the full Internet BGP routing table into the Internet access VPN
• C.The customer that needs the Internet access service is assigned to the same RTs as the Internet gateway
• D.The Internet gateway router is connected as a PE router to the MPLS backbone.

Comment: *

Name: *

Email: *

Verification: *