An organization uses Cisco FMC to centrally manage multiple Cisco FTD devices The default management port conflicts with other communications on the network and must be changed What must be done to ensure that all devices can communicate together?

• A.Set the sftunnel to go through the Cisco FTD
• B.Change the management port on Cisco FMC so that it pushes the change to all managed Cisco FTD devices
• C.Set the sftunnel port to 8305.
• D.Manually change the management port on Cisco FMC and all managed Cisco FTD devices

Comment: *

Name: *

Email: *

Verification: *

An engineer is configuring a Cisco ESA and wants to control whether to accept or reject email messages to a recipient address.
Which list contains the allowed recipient addresses?

• A.BAT
• B.HAT
• C.SAT
• D.RAT

Comment: *

Name: *

Email: *

Verification: *

Which two are valid suppression types on a Cisco Next Generation Intrusion Prevention System? (Choose two)

• A.Rule
• B.Application
• C.Protocol
• D.Source
• E.Port

Comment: *

Name: *

Email: *

Verification: *

Which two conditions are prerequisites for stateful failover for IPsec? (Choose two.)

• A.The active and standby devices must run the same version of the Cisco IOS software and must be the same type of device
• B.The IPsec configuration that is set up on the active device must be duplicated on the standby device.
• C.Only the IKE configuration that is set up on the active device must be duplicated on the standby device; the IPsec configuration is copied automatically.
• D.Only the IPsec configuration that is set up on the active device must be duplicated on the standby device; the IKE configuration is copied automatically
• E.The active and standby devices can run different versions of the Cisco IOS software but must be the same type of device.

Comment: *

Name: *

Email: *

Verification: *

Which two deployment model configurations are supported for Cisco FTDv in AWS? (Choose two.)

• A.Cisco FTDv configured in routed mode and managed by an FMCv installed in AWS
• B.Cisco FTDv with one management interface and two traffic interfaces configured
• C.Cisco FTDv configured in routed mode and managed by a physical FMC appliance on premises
• D.Cisco FTDv with two management interfaces and one traffic interface configured
• E.Cisco FTDv configured in routed mode and IPv6 configured

Comment: *

Name: *

Email: *

Verification: *