Your network operations team is deploying Access Control Lists (ACLs) across your Internet gateways. They wish to place an ACL inbound on the Internet gateway interface facing the core network (the "trusted" interface). Which IP address would the ACL need for traffic sourced from the inside interface, to match the source address of the traffic?

• A.inside global
• B.outside global
• C.inside local
• D.outside local

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Refer to the exhibit. Two data center sites (X and Y) connect to the Internet and each other using a backdoor link. Both advertise the same IP prefix (100.75.10.0/23) to the Internet. Firewalls are behind R1 and R2.
Problem: When users attempt to reach 100.75.10.0/23, the return traffic is routed to Site-Y, regardless of where the session originated. This results in asymmetric traffic and potentially broken sessions due to firewall behavior.
Which design resolves the issue?

• A.Use BGP MED to influence Site-X return traffic. Change the IP address scheme of both sites.
• B.Change the Site-Y firewall configuration to replicate the Site-X configuration. Advertise the low MED attribute on Site-X to the Internet.
• C.Add a static route toward the Internet on Site-X. Change the DNS policy on Site-Y to block traffic.
• D.Establish control plane peering between edge routers. Have Site-X advertise an IP pool with a longer prefix.

Comment: *

Name: *

Email: *

Verification: *

Which two conditions must be met for EIGRP to maintain an alternate loop-free path to a remote network?
(Choose two.)

• A.The Reported Distance from a successor is lower than the local Feasible Distance.
• B.The Reported Distance from a successor is higher than the local Feasible Distance.
• C.The feasibility condition does not need to be met.
• D.The Feasible Distance from a successor is lower than the local Reported Distance.
• E.A feasible successor must be present.

Comment: *

Name: *

Email: *

Verification: *

Which option is a fate-sharing characteristic in regards to network design?

• A.A failure of a single element causes the entire service to fail
• B.It acts as a stateful forwarding device
• C.It provides data sequencing and acknowledgment mechanisms
• D.It protects the network against failures in the distribution layer

Comment: *

Name: *

Email: *

Verification: *

Drag and Drop Question
Drag and drop the optical technology design characteristics on the left to the correct optical technologies on the right. Not all options are used.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *