Users are unable to reach an application. The BIG-IP Administrator checks the Configuration Utility and observes that the Virtual Server has a red diamond in front of the status. What is causing this issue?

• A.All pool members have been disabled.
• B.The Virtual Server is disabled.
• C.All pool members are down.
• D.The Virtual Server is receiving HTTPS traffic over HTTP virtual.

Comment: *

Name: *

Email: *

Verification: *

Refer of the exhibit.

The 816-IP Administrator runs the command shown and observes a device trust issue between BIG-IP devices in a device group. The issue prevents config sync on device bigip3.local.
What is preventing the config sync?

• A.Next Active Load factor is 0 on bigip1.local
• B.Both devices are standby
• C.Next Active Load factor is 1 on bigip1.local
• D.Time Delta to local system is 12

Comment: *

Name: *

Email: *

Verification: *

The incoming client IP address is 205.12.45.52. The last five connections have been sent to members C, D, A, B, B. Given the virtual server and pool definitions and the statistics shown in the graphic, which member will be used for the next connection?

• A.10.10.20.2:80
• B.10.10.20.1:80
• C.10.10.20.4:80
• D.10.10.20.3:80
• E.10.10.20.5:80

Comment: *

Name: *

Email: *

Verification: *

A BIG-IP Administrator opens a case with F5 Support. The support engineer requests the BIG-IP appliance chassis serial number.
Which TMSH command will provide this information?

• A.show /sys hardware
• B.. list /sys software
• C.list/sys diags
• D.show /sys version

Comment: *

Name: *

Email: *

Verification: *

Assuming that systems are synchronized, which action could take place if thEl eo fv ae ir lcable is connected correctly and working properly, but the systems cannot communicate over the network due to external network problems.

• A.If network failElover is enabled, the standby system will assume the active mode.
• B.If network failElover is enabled, the standby system will go into active mode but only until the network recovers.
• C.Whether or not network failElover is enabled, the standby system will assume the active mode.
• D.Whether or not network failElover is enabled, the standby system will stay in standby mode.

Comment: *

Name: *

Email: *

Verification: *