-- Exhibit -


-- Exhibit --
Refer to the exhibits.
How should the LTM Specialist minimize the configuration?

• A.Create a single monitor, apply it to the pool, and remove the pool member level monitors.
• B.The configuration is as minimized as possible.
• C.Remove the pool member level monitors.
• D.Create a single monitor and apply it to each pool member.

Comment: *

Name: *

Email: *

Verification: *

Users are experiencing low throughput when downloading large files over a high-speed WAN connection.
Extensive packet loss was found to be an issue but CANNOT be eliminated.
Which two TCP profile settings should be modified to compensate for the packet loss in the network? (Choose two.)

• A.slow start
• B.proxy options
• C.proxy buffer low
• D.proxy buffer high
• E.Nagle's algorithm

Comment: *

Name: *

Email: *

Verification: *

An LTM Specialist has set up a custom SNMP alert.
Which command line tool should the LTM Specialist use to test the alert?

• A.testlog
• B.logtest
• C.snmptest
• D.logger

Comment: *

Name: *

Email: *

Verification: *

A high-availability (HA) pair configuration uses only the hardwire serial cable connection to determine device state. A power outage occurs to the PDU powering the active unit. The standby unit takes over the active role as expected.
How is the peer unit able to determine the active unit is unavailable?

• A.no response on management interface
• B.no heartbeat packets received on self IPs
• C.voltage loss on serial cable
• D.no data stream received on serial port

Comment: *

Name: *

Email: *

Verification: *

A new VLAN vlan301 has been configured on a highly available LTM device in partition ApplicationA. A new directly connected backend server has been placed on vlan301. However, there are connectivity issues pinging the default gateway. The VLAN self IPs configured on the LTM devices are 192.168.0.251 and 192.168.0.252 with floating IP 192.168.0.253. The LTM Specialist needs to perform a packet capture to assist with troubleshooting the connectivity.
Which command should the LTM Specialist execute on the LTM device command line interface to capture the attempted pings to the LTM device default gateway on VLAN vlan301?

• A.tcpdump -ni vlan301 'host 192.168.0.253'
• B.tcpdump -ni /ApplicationA/vlan301 'host 192.168.0.253'
• C.tcpdump -ni vlan301 'host 192.168.0.251 or host 192.168.0.252'
• D.tcpdump -ni /ApplicationA/vlan301 'host 192.168.0.251 or host 192.168.0.252'

Comment: *

Name: *

Email: *

Verification: *